You may be wondering what the Samsung dryer error codes mean. In general, a code begins with F. This means that there’s a problem with the motor or drive mechanism. Sometimes, the error code will be E. If you’re not sure, read on for more information. Then, if your Samsung dryer still can’t operate, it may be the fault of a faulty door or belt.
In some cases, a Samsung dryer error code will indicate that the door may not be closing properly. It may be because you didn’t close it properly when you first installed it or because the door latch is broken. Either way, you’ll likely see the letters dC, dE, or dF, which mean that the door isn’t closing. If this sounds like the case, it’s time to look for the obvious causes and fix them as quickly as possible. If you’re not able to fix the door latch on your own, you’ll want to take the unit to a service center.
A few common Samsung dryer errors are listed below. The first is et. This means that the control board has failed. If the code appears, unplug the dryer and wait five minutes before powering it on again. If the error goes away, it’s most likely the fault with a control board. Depending on the error code, you may need to contact a repair service center. Remember that opening the back of the dryer may void the warranty.
A dE error code may be displayed when the board power is flickering. In this case, you’ll need to reset the board before attempting repairs. If this does not solve the problem, a qualified technician will need to inspect the entire dryer to determine the issue. If you don’t find a solution for this, call a Samsung Appliance Repair service to help you. If the dE code persists, the next step is to replace the control board.
If a reset is unsuccessful, you may be able to reset your Samsung dryer by performing a power cycle. This will reset the network. However, it may take a few minutes for your dryer to be fully reset. Make sure you unplug it for at least 10 minutes before attempting to reset it again. If the problem is still persists, it is recommended that you seek the help of a qualified Samsung dryer repair service technician.
Resetting the Samsung dryer can also reset some of its internal components. This process can be completed by unplugging it from the wall receptacle and turning off the circuit breakers. After a few minutes, the unit should work as normal again. If it doesn’t, it’s likely to need to be replaced. If the heating element or thermal fuse is faulty, a technician can check for these problems and make sure that they are not related to the thermal fuse.