If you have an HP printer, you may notice the error code 04358A98 on the screen. This error can occur for a variety of reasons, including firmware or fuser issues. Depending on the model and brand of printer, this error may also occur during warm-up or during the timeout function. High temperature can also lead to this issue, or a bad mains supply. For more information, see the troubleshooting section below.
If your HP printer keeps giving you this error, the most common cause is a problem with the toner. If you have just replaced the toner cartridge, you may not have removed the sealing tape. If the toner is running low, you may need to reinstall it or increase the amount of paper you’re printing. If the printer is using a fan, it can also be a cause for the error code. If you need assistance, contact an HP engineer.
To resolve this error, you may need to update the firmware or try replacing the printer cartridge. HP printers can also have problems with surge protectors, UPS connections, and manual starts. Make sure to reconnect the USB cable to the computer and try again. It may also be necessary to reinstall the printer drivers. You should also try removing the printer and running a troubleshooter. If you still cannot resolve the error, you may need to clean the head of your HP printer.
You can also install a new driver from the HP website. To do this, open the HP official web site on your personal computer and click on the Support & Drivers tab. You will need to enter your printer model number and click search. You will then be prompted to install the latest driver for the printer. Then, your HP printer should work properly. The only problem with this method is that your HP printer does not have the HP printer software.
If the above steps do not work, you should try connecting the HP printer to a USB 2.0 port. This will allow the printer to communicate with your computer, which will eliminate the error. Afterward, you should restart your printer. After two minutes, you should be able to print the document again. The problem may be a simple one. However, if you keep repeating the same error message, you may need to change the USB port or install a new driver for your HP printer.
Besides installing a new driver, HP printers may also have hardware and software problems. To prevent this, it is a good idea to check for ink cartridge problems first. These can lead to blue screens. You can try removing and replacing the cartridges to resolve the problem. If this does not work, you should check your power cord and cartridges. Then, try rebooting your HP printer and see if it works.